Miner Deep Cleaning & Refurbishment

Stage two: everything comes apart, gets cleaned, gets new thermal interface and goes back together. It is the least glamorous part of the line and the one that decides whether the burn-in numbers afterwards mean anything. Part of our used miner services.

Full teardown

Boards out, heatsinks off, not blown out in place

Thermal renew

Paste and pads replaced, not topped up

Fan service

Bearing check, replacement where needed

Then measured

Thermal validation before the burn-in test

Why cleaning is a performance item, not cosmetics

A used miner arrives with years of dust packed into the heatsink fins. The chip still works, but it cannot shed heat, board temperature climbs, and the firmware responds the only way it can: it derates the unit to protect it. Hashrate falls while wall power barely moves — the worst possible trade.

Cleaning restores airflow; renewing the thermal interface restores the heat path from chip to heatsink. Only after both does a burn-in test measure the machine instead of the dust. On a batch of used units that is what separates a graded machine from a gamble.

What refurbishment covers

Boards & heatsinks

Dry and contact cleaning of hashboards, fin-by-fin heatsink clearing, corrosion removal on traces and pads.

Thermal interface

Old paste and pads stripped and replaced on chips, power stages and control boards.

Fans & airflow

Fan testing, bearing service, replacement of tired or noisy units, shroud and duct refitting.

Connectors & wiring

Header, ribbon and power connector inspection; heat-damaged or loose connectors replaced.

Case & frame

Case cleaning, bent frame correction where practical, missing screws and standoffs replaced.

Thermal validation

A short loaded run confirming temperatures settle correctly before the full burn-in.

Boards that fail during teardown go back to the repair bench rather than forward to the shelf — the inspection and repair stage always wins over the schedule.

Refurbishment questions

Is cleaning really worth it on a used miner?
Dust is the cheapest performance loss to fix. A clogged heatsink raises board temperature, the firmware derates the unit, and hashrate drops while wall power stays high. Cleaning plus thermal renewal usually recovers that headroom.
What does a full refurbishment include?
Full teardown, board and heatsink cleaning, corrosion removal, thermal paste and pad renewal, fan service, connector inspection, case cleaning, reassembly and thermal validation.
Do you clean boards that are still working?
Yes. Working boards benefit too: cleaning removes conductive dust and corrosion that cause intermittent faults later. Faulty boards are repaired first, then cleaned.
Can refurbishment fix a noisy miner?
Usually the noise is a fan bearing at end of life, not firmware. Bearing service or replacement plus restored airflow is part of this stage, and fans are checked again during burn-in.

Refurbish before you sell

A cleaned, thermal-refreshed machine is worth more and sells faster than a dusty one. Send the model mix.